相反电荷聚电解质/表面活性剂体系界面行为研究新进展

介绍了中子反射在相反电荷聚电解质/表面活性剂体系的界面行为研究中的基本原理.在阐述经典的弱相互作用体系的界面吸附行为和表面张力曲线的基础上,分析了聚合物浓度、电解质、表面活性剂疏水基链长对相反电荷聚电解质/表面活性剂体系表面张力曲线的影响,并结合中子反射实验结果,根据相反电荷聚电解质/表面活性剂体系的表面张力曲线是否出现突跃峰,将其界面吸附行为分为两类并提出了两种类型表面张力曲线对应的理论模型.     

Rapid analysis of the essential oil components of dried Zanthoxylum bungeanum Maxim by Fe2O3‐magnetic‐microsphere‐assisted microwave distillation and simultaneous headspace single‐drop microextraction followed by GC–MS

In this work, microwave distillation assisted by Fe₂O₃ magnetic microspheres (FMMS) and headspace single‐drop microextraction were combined, and developed for determination of essential oil compounds in dried Zanthoxylum bungeanum Maxim (ZBM). The FMMS were used as microwave absorption solid medium for dry distillation of dried ZBM. Using the proposed method, isolation, extraction, and concentration of essential oil compounds can be carried out in a single step. The experimental parameters including extraction solvent, solvent volume, microwave power, irradiation time, and the amount of added FMMS, were studied. The optimal analytical conditions were: 2.0 μL decane as the extraction solvent, microwave power of 300 W, irradiation time of 2 min, and the addition of 0.1 g FMMS to ZBM. The method precision was from 4 to 10%. A total of 52 compounds were identified by the proposed method. The conventional steam distillation method was also used for the analysis of essential oil in dried ZBM and only 31 compounds were identified by steam distillation method. It was found that the proposed method is a simple, rapid, reliable, and solvent‐free technique for the determination of volatile compounds in Chinese herbs.     

Simultaneous derivatization and air-assisted liquid–liquid microextraction of some aliphatic amines in different aqueous samples followed by gas chromatography-flame ionization detection

The paper presents a new method based on simultaneous derivatization and air-assisted liquid–liquid microextraction (AALLME) for the extraction and preconcentration of some aliphatic amines prior to gas chromatography-flame ionization detection (GC-FID). Primary aliphatic amines are derivatized and extracted simultaneously by a fast reaction with butylchloroformate (derivatization agent/extraction solvent) under mild conditions. The mixture of butylchloroformate and aqueous sample solution is rapidly sucked into a 10-mL glass syringe and then is injected into a test tube with conical bottom and the procedure is repeated seven times. After centrifuging the resulted cloudy solution, the derivatized analytes in the sedimented phase are determined by GC-FID. The influence of main factors on the efficiency of derivatization/extraction procedure is studied. Under the optimal conditions, the enrichment factors (EFs) for aliphatic amines are obtained in the range of 248–360 and limits of detection (LODs) are between 0.30 and 2.6 μg L⁻¹. The obtained extraction recoveries ranged from 50 to 72% and the relative standard deviation (RSD) was less than 4.8% for intra-day (n = 6) and inter-days (n = 4) precision. The method is successfully applied to determine some aliphatic amines in environmental water samples.     

Nonrandom adsorption of polyelectrolyte chains on finite regularly charged surfaces

Adsorption phenomena are relevant in a wide variety of subjects, from biophysics to technological applications. Different aspects, such as molecular recognition, multilayer deposition, and dynamics of polymer adsorption have been addressed. The methodologies used range from analytical and numerical methods to molecular dynamics or Monte Carlo simulations. In this work, a coarse‐grained model is used to explore the adsorption of charged backbones to oppositely charged regions of a surface. These regions encompass those small enough to prevent complete adsorption, but extend to surfaces sufficiently large to promote adsorption with minimal effect on the three‐dimensional conformation in bulk. Apart from the different surface areas explored, variations on the surface charge density, polyelectrolyte chain length, and chain stiffness were also considered. The degree of compaction of the polyelectrolyte, on adsorption, is different from that found in the bulk. Also, results indicate an nonuniform adsorption pattern on regularly charged surfaces. © 2013 Wiley Periodicals, Inc.     

Rheological Study of Interactions between Anionic Guar and Oppositely Charged Surfactant

We have studied the interactions between anionic carboxymethyl guar (CMG) and oppositely charged surfactant: dodecyltrimethylammonium bromide (DTAB), tetradecyltrimethylammonium bromide (TTAB), cetyltrimethylammonium bromide (CTAB), and gemini surfactants (16-4-16), using rheological measurements. In the present study, two competing forces, electrostatic interaction and hydrophobic interaction, have been identified as important factors. Various types of structure formed on the anionic CMG chains are qualitatively discussed in comparison. For example, C₁₂TAB and gemini surfactant tend to form polymer-bound aggregates, whereas the C₁₆TAB tend to form the polymer-associated architecture. Furthermore, possible mechanisms based on the experimental results to elucidate these interesting phenomena have been proposed and discussed.     

Pressure Drop and Performance Characteristics of Water-Based Al2O3 and CuO Nanofluids in a Triangular Duct

An experimental study is performed to determine the pressure drop and performance characteristics of Al₂O₃/water and CuO/water nanofluids in a triangular duct under constant heat flux where the flow is laminar. The effects of adding nanoparticles to the base fluid on the pressure drop and friction factor are investigated at different Reynolds numbers. The results show that at a specified Reynolds number, using the nanofluids can lead to an increase in the pressure drop by 35%. It is also found that with increases in the Reynolds number, the rate of increase in the friction factor with the volume fraction of nanoparticles is reduced. Finally, the performance characteristics of the two nanofluids are investigated using the data of pressure drop and convective heat transfer coefficient. The results show that the use of Al₂O₃/water nanofluid with volume fractions of 1.5% and 2% is not helpful in the triangular duct. It is also concluded that at the same volume fraction of nanoparticles, using Al₂O₃ nanoparticles is more beneficial than CuO nanoparticles based on the performance index.     

Determination of Drop Sizes in Annular Gas/Liquid Flows in Vertical and Horizontal Pipes

Measurement of drop sizes play vital role in applications dealing with gas/liquid flow mixtures. In the present work, drop sizes in vertical and horizontal pipe flows were determined using Malvern 2600HSD system that applies laser diffraction method. From the analysis of the experimental data obtained at two different pipe orientations, two separate expressions were developed to determine Sauter mean diameter, d ₃₂. Except for the 20 m/s superficial gas velocity in vertical flow case, a good agreement was found between the developed expressions and the experimental data.     

INDUSTRIAL NEWS

Interactions between monolayers of trilaurylamine (TLA) and various water-soluble corrosion, hydrate and scale inhibitors, as well as acetic acid and FeCl₂, have been studied by means of the Langmuir technique, The water-soluble compounds were present in the subphase before TLA was spread. Their influence on the monolayer properties were measured by means of surface pressure-area ( k-A) isotherms and constant surface pressure-area relaxation measurements. All the added water soluble species gave rise to monolayer expansion. The monolayer expansion observed for TLA at pH 1, increased when FeCl₂ was added to the subphase at the same pH. Polyethyleneglycols with molecular weight higher than 200 destabilized totally the TLA-monolayer, probably due to bending and folding into multilayers. Monolayer expansion and film instability increased with increased acetic acid concentrations. The destabilization mechanism in this case was most likely due to a combination of nucleation and dissolution of film components into the subphase. The corrosion inhibitor Dyno KI 384 had a higher surface activity than TLA. Hence the monolayer     

Study of Bimodal Drop Size Distributions of Emulsion

In order to increase the present understanding of bimodal emulsion drop size distributions, systematic series of experiments have been carried out to investigate the effects of formulation variables on bimodal drop size distributions, and probability distribution functions were proposed to analyze the distribution. The results show that, the span of the drop size and Sauter mean diameter become larger when the dispersed phase volume fraction becomes higher and rotor speed becomes lower; the Frechet function represents the experimental data satisfactorily. The prediction model of Sauter mean diameter established by combining the prediction theory of the maximum stable drop diameter and experimental analysis results can fit the experimental data well.     

The Influence of Water Vapor on the Electrochemical Shift of an Ionic Liquid Measured by Ambient Pressure X-ray Photoelectron Spectroscopy

Ionic liquids (ILs) are considered to be one of the steppingstones to fabricate next generation electrochemical devices given their unique physical and chemical properties. The addition of water to ILs significantly impact electrochemical related properties including viscosity, density, conductivity, and electrochemical window. Herein we utilize ambient pressure X-ray photoelectron spectroscopy (APXPS) to examine the impact of water on values of the electrochemical shift (S), which is determined by measuring changes in binding energy shifts as a function of an external bias. APXPS spectra of C 1s, O 1s and N 1s regions are examined for the IL 1-butyl-3-methylimidazolium acetate, [C₄mim][OAc], at the IL/gas interface as a function of both water vapor pressure and external bias. Results reveal that in the absence of water vapor there is an IL ohmic drop between the working electrode and quasi reference electrode, giving rise to chemical specific S values of less than one. Upon introducing water vapor, S values approach one as a function of increasing water vapor pressure, indicating a decrease in the IL ohmic drop as the IL/water mixture becomes more conductive and the potential drop is driven by the electric double layer at the electrode/IL interface.